How to warm the floor will be split or how to care
| wangkiky 760 | ||
|
To warm the floor by floor radiant heating, indoor temperature uniformity, temperature, radiation from the ground up, from the bottom up decreasing. Here we look at the introduction to warm the floor warping and cracking, as well as wood flooring maintenance methods. Introduction to warm the floor warping and cracking, and 1, in the warm cement backfill yet fully dry conditions, premature Paving wood floors. Because after wood floor paving, concrete moisture continues to evaporate, so that the already relatively dry moisture content of the wood floor is raised, so the expansion drum Alice. 2, warm wood floor is not good quality, without strict drying, whereby the moisture content is too high, after use, as the water content decreases, wood shrinkage cracks. In fact, this floor, that is not used to warm the heating chamber be equally split. Warm floor maintenance, one, when installing floor insulation should pay attention to when using geothermal floor, consumers must pay attention to the gradual floor and underfloor heating. Before installation, to cement the ground gradually warming up, increase the 5 ℃ every day, until the standard is reached about 18 ℃. During the first 3 days after the installation is complete, we must continue to maintain this temperature for 3 days before needed to heat up, and only a day to heat up 5 ℃.Second, pay attention to gradual warming, the first use of geothermal heating, attention should be slow to heat up. First use, three days before the start of heating to the gradual warming: the first day the water temperature 18 ℃, the next day 25 ℃, the third day of 30 ℃, the temperature rose to normal before the fourth day, the water temperature is 45 ℃, the surface temperature of 28 ℃ ~ 30 ℃. Not heat up too fast, too fast, the floor may occur due to expansion cracks distortions. In addition, after a long enabled geothermal heating system again, want to be like the first time, as strict accordance with the heating temperature program. Third, the surface temperature is not too high, it is noted that the use of geothermal heating, surface temperature should not exceed 28 ℃, the water temperature should not exceed 45 ℃, if more than this temperature, it will affect the life of the floor and use cycle. The average family, the winter temperature reaches about 22 ℃, it is very comfortable, normal warming, it will not affect the use of geothermal floor. Related links: [url="http://bestwpcforsale.com/blog"]Wpc Market prospects[/url] [url="http://www.bestwpcforsale.com"]Best Wpc Material Whosale[/url] [url="http://bestwpcforsale.com/blog/waterproof-outdoor-floor.html"]Waterproof Outdoor Wood Floor[/url] |
||
